Device Management
DVR User Manual
90
11
Device Management
11.1 Network Configuration
11.1.1 TCP/IP Configuration
Click Start
Settings
Network
TCP/IP to go to the following interface. Check “Obtain an
IPv4 address automatically”, “Obtain an IPv6 address automatically” and “Obtain DNS
automatically” to get the network addresses automatically, or manually enter the network
addresses. You can modify the MTU value according to the network condition (MTU,
Maximum Transmission Unit, can be modified according to network condition for higher
network transmission efficiency). Click “Apply” to save the settings.
Multiple Ethernet Ports Setting
If the DVR has two network ports or above, you can select the network work pattern as
required.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the “Network Fault
Tolerance” pattern. There are many advantages of this work pattern: 1. increase the bandwidth;
2. form a network redundant array to share the load. When a failure happens to one network
port, the other port will take over the entire load immediately. The takeover process is seamless
and the network service will not be broken off.
If “Network Fault Tolerance” is selected, check “Obtain an IPv4 address automatically”,
“Obtain an IPv6 address automatically” and “Obtain DNS automatically” to get the network
addresses automatically, or manually enter the network addresses; select one Ethernet port as
the primary card and then click “Apply” to save the settings.
Multiple Address Setting:
If “Multiple Address Setting” is selected, the IP addresses of the two Ethernet ports should be
set respectively.
Summary of Contents for PDVR-S4L15
Page 1: ...1080P 4 Channel NVR PDVR S4L15...
Page 128: ...Compatible Device List DVR User Manual 120 Fig 9 2...
Page 135: ...A7...
