SL-224-H-P300
Fax
:021-66402031
Www.techs.is , [email protected]
Page
15
Second, confirm the Rx and Tx ports of the fiber module when connecting, insert one end of
the fiber into the Rx and Tx ports correspondingly, ensure that the Tx and Rx ends of the
interface are connected correctly and the other end of the fiber is connected to another device;
Third, please check the corresponding indicator light status after power on. If the light blinking
that the link is properly connected, if the light is off, the link is failure, please check the line to
confirm that the corresponding equipment is enabled.
Note
：
Does not allow excessive bending fiber, the radius of curvature should not be
less than 10cm;
Ensure the cleanliness of the fiber surface;
Please do not look directly into the optical fiber connector with your eyes as this may cause
eye injury
3.3 Check before power on
1.
Check whether the outlet power supply meets the switch specifications;
2.
Check the power, switches, racks and other equipment have been properly grounded;
3.
Check whether the switch and other network devices are connected properly .
3.4 Device initialization
The switch automatically initializes when the power switch is turned on.
Indicator will appear the following situation:
After the power is turned on, the power indicator remains on, the other indicator is off at this
time;
After about 1 second, all lights except for the power light turn on for about 35 seconds and
then turn off; when the SYS light goes flashing, the system runs normally
Port LEDs indicates the connection status of each port, indicating that the switch has started
to work normally
3.5 Web Login
Step1: In the normal operation of the device, connect the computer to the switch's RJ45 port
by network cables
