Install the propeller adapter onto your motor, using
the screws provided with your motor. Install the motor
mount onto your motor, using the screws provided
with your motor.
Glue the firewall to the head of the plane
.
Install the motor assembly onto the firewall, using the
four wood screws
provided.
PRO TIP
After flying the airplane, you may want to add
right and/or down
thrust to the motor. You can do this
by adding thin washers between the
motor mount and
the firewall.
Cut two pieces of carbon fiber rod , then cut two
pieces of heat-shrink tubing to a length of 1-1/2" (38mm).
Cut two pieces of plain wire to a length of 1-1/2" (38mm), then
make a
L
-
Bend in one end of each piece of wire and a 4mm
long 90º bend in the
other end of each piece of wire.
Secure one piece of wire to one end of the carbon fiber
rod, using one
piece of heat-shrink material. The piece
of wire should overlap the carbon
fiber rod at least 1"
(25mm). Heat the heat-shrink material with a heat gun
to shrink it into place.
PRO TIP
For extra security, apply
a few drops of foam-friendly thin C/A
to the end of the
pushrod and allow it to "wick" into the joint.
Summary of Contents for Malibu-F3P
Page 1: ......
