Slide one plywood pushrod supports over the end of
the carbon fiber
rod and temporarily push the
plywood pushrod supports into the one precut slots
in the fuselage.
Center the elevator and rudder servos, then glue the
servo arms on .
Install the horn of aileron same as the horn of stabilizer
.
Install wheel covers on the chock beside the wheel.
Screw one more chock outside of the cover, glue it.
Make sure that both landing
gear strut are even with each
other(the same distance from
the bottom of the wing)or else
the airplane won't sit level on
the ground.
Install the two wheels and wheel chocks.keep
1 m m d i s t a n c e b e t w e e n w h e e l a n d i t s
chock.Apply some foam-friendly thick C/A to
glue the chocks.
Install the elevator aileron and rudder servos into
the servo mounting hole in the right side of the
fuselage.Use a dab of foam-friendly thick C/A to
secure them into place.Because the size of servos
are different,you may need to cut the servo mounting
hole larger to fit your particular servos.
Summary of Contents for Malibu-F3P
Page 1: ......
