5
．
Bracing
Cut the two carbon rods. One end
of the carbon rod is fixed into the
hole of the fin with the foam
－
friendly C
／
A and the other end is
fixed into the hole
of
the
fuselage
．
Make sure they are vertical
．
Position the carbon rods in the
fuselage, gluing the rods to the
vertical fuselage ONLY. This will
allow for alignment of the fuselage
in the next step.
4
．
Rudder
Cut
a 45
bevel into the bottom
leading edge of the rudder.
－
3
－
57m
m
5 m
m
7
3
depth
：
3mm
length
：
12mm
F
some foam-friendly C/A
ixed with
．
It is similar to assemble the fuselage bracing, as you want the rods to be
glued to the carbon
bracing that has been preinstalled
on the wing and fuselage. The rods are staggered and
fit into
notches in the fuselage. Make sure the rods
are straight and are not flexing the wing. Use foam-
friendly C/A
to glue the rods in position. The wing
should be flat and parallel to the horizontal
stabilizer,while also being perpendicular to the vertical fuselage. Use side cutters to trim away any
Hold the two carbon rods
together with a line and
s
．
ome C/A
Same as assembly of elevator
Same as above steps
