Techogas RN483GXSS, Installation Manual

Page: 19 / 32

19
General Information
READ AND FOLLOW ALL
WARNING AND CAUTION
INFORMATION WHEN INSTAL-
LING THIS APPLIANCE.
• All openings in the wall behind the
appliance and in the floor under the
appliance must be sealed.
• Do not obstruct the flow of
combustion and ventilation air.
Moving, Handling and Unpacking
Remove and discard all packing
materials, including cardboard and tape
on the outside and inside of the range.
Remove the burner grates and
styrofoam off the top cooking surface. Be
sure to remove the burner caps packaged
in styrofoam below the burner grates.
Do not discard the anti-tip
metal bracket supplied with the
range.This is the anti-tip device and must
be installed with the unit. Refer to“An-
ti-tip Device Installation”
section.
Some stainless steel parts may have a
plastic protective wrap which must be
peeled off.The interior should be wa-
shed thoroughly with hot, soapy water
to remove film residues and any dust or
debris before being used, then rinsed and
wiped dry.
Solutions stronger than soap and water
are rarely needed.
CAUTION
Avoid any damage to oven vents.
The vents need to be un obstructed and
open to provide proper airflow for opti-
mal oven performance.
CAUTION
The cooling fans should be operating
when the unit is in operation. If you noti-
ce the cooling fans are not operating or
you observe unusual or excessive noise
coming from the cooling fans, contact a
TECNOGAS SUPERIORE Service Center
before continuing operation. Failure to do
so can result in damage to the oven or
surrounding cabinets.