Technoplus multiflex 80280, Operating Instructions Manual

Page: 29 / 48

TROUBLESHOOTING AND FAULT RECOVERY
Version 1.0 29
11. Troubleshooting and fault recovery
The following overview provides information about faults, their causes and remedies.
In the event that a fault cannot be rectified despite using the table, please contact your
supplier.
No. Fault Possible causes / Remedy
Compressed air attach, adjust manometer gauge to 6
bar.
1. Machine fails to move
Release the EMERGENCY STOP button
Swing the insertion frame all the way up
2. Motor fails to start
Turn on the main switch
3.
Motor turns, the tool
doesn’t.
Clutch defectively, contact manufacturers
Controll the motor direction of rotation, only by means
of specialists
Exchange blunt tools
4.
Tool fails to drill
properly
Tighten the locking lever at the drilling head
Too little compressed air available, adjust manometer
gauge to 6 bar.
5.
Fitting is not cleanly
pressed in
correct the right insertion position
6. Stroke too fast/slowly Pneummatics throttle close/open