Page
8
of
44
TRAÇABILITÉ CRÉATIVE
CREATIVE TRACEABILITY
www.technomark-marking.com
Version from 04/11/2015
TECHNOMARK
3 Allée Michaël FARADAY
Parc d’activités STELYTEC
42400 SAINT-CHAMOND (France)
Tel: +33 (0) 4 77 22 25 91
Fax: + 33 (0) 4 77 22 38 93
E-mail : [email protected]
Warning, dangerous moving parts, keep fingers and other body parts at a safe distance.
When used intensively the active part of the machine (impact unit solenoid) may exceed a
temperature of 70° C. Do not work on this element without adequate protection and/or letting it cool
before servicing.
7.
IT IS RECOMMENDED THAT SAFETY GLASSES BE WORN DURING THE MARKING CYCLE. Injuries can be
caused by shards from the marked surface.
8.
Because the machine operates by a succession of impacts which generates vibrations, it should be
secured in line with accepted trade practices. We also recommend placing the machine on a solid
base in order to reduce noise emission and vibrations.
9.
DO NOT PLACE YOUR HANDS UNDER THE MACHINE DURING THE MARKING OPERATION, there could
be the risk of cuts and/or jamming between the stylus and the part.
10.
DEPENDING ON THE PART TO BE MARKED AND THE DESIRED IMPACT DEPTH THE SOUND LEVEL OF
YOUR MACHINE MAY EXCEED 70dB(A). Use ear plugs during the marking phase
1.
NEVER CONNECT-DISCONNECT THE MARKING HEAD WHEN THE CONTROL UNIT IS ON (especially
during marking).
Incorrect connections can seriously damage or destroy the electronic components of your machine
and void the guarantee.
2.
NEVER TIGHTEN OR LOOSEN THE KNURLED NUT ON THE IMPACT UNIT USING PLIERS OR ANOTHER
TOOL. Manually tightening is enough.
This could severely damage your machine's electronics. This operation will void the unit's
guarantee.
3.
YOUR EQUIPMENT HAS BEEN DESIGNED FOR USE IN MANY SITUATIONS. REGARDLESS OF YOUR
EQUIPMENT'S USE, AVOID VIOLENT AND POWERFUL IMPACTS TO BOTH ELEMENTS THAT FORM
YOUR MACHINE. AVOID IMPACTS ON THE FRONT SECTION OF YOUR COMMAND CONTROL UNIT.
You might damage one of the keys on the keyboard or the screen.
4.
KEEP YOUR DEVICE AND ITS CABLES AWAY FROM SOURCES THAT GENERATE PARASITES (ex. :
welding machine, high frequency generating source…).
5.
NEVER MARK WITH THE MACHINE EMPTY (WITHOUT A PART TO MARK UNDER THE MARKING
HEAD). The height between the stylus and the part to be marked must NEVER exceed 9.5mm
during marking. This operation can destroy your stylus. (See
8.1.2 Positioning distance relative to
the parts to mark)