EN 2
INSTALLATION
BACKUP BATTERY INSTALLATION
Your clock radio requires one CR2032 lithium battery (not included) to provide backup power to the
clock in the event of a temporary power interruption.
If AC power is interrupted, the LED display will go off and both the radio and the alarm will not function.
The backup battery will keep the time and all settings of your unit. Make sure a fresh CR2032 lithium
battery is used. A fresh CR2032 battery could backup your clock continuously for around 3 days.
SETTING TIME, 12/24HR TIME AND THE SNOOZE DURATION
1. Press
SET
once, the hour digits flash. Press
or to set the current hour (hold to advance
rapidly).
2. Press
SET
again, the minute digits flash. Press or to set minutes. (hold to advance
rapidly).
3. Press
SET
again, the display shows “
24H
” and flashes. Press
or to select “
12H
” or “
24H
”
time format.
4. Press
SET
again, the display shows “
05
” and flashes. Press
or to select your snooze
time from 5 to 60 minutes.
5. Press
SET
again or if no key is pressed in approx. 10 seconds to exit the setting mode.
Note: when 12-hour time format is selected, the
P
(PM) LED will appear at the lower middle part of
the time display to indicate the afternoon time; there is no AM indicator.
Note:
Plug the AC/DC power adapter
AS0601A-0500600EUL
into an AC household outlet and then
plug the DC jack into the backside of the clock. Your radio clock is powered now.
1. Place your clock face down on a flat surface.
2. Remove the screw from the battery compartment cover. Slide and remove the cover from the
bottom of your clock.
3. Insert one new CR2032 lithium battery into the battery compartment with the + side facing up
as indicated.
4. Slide the cover back on the battery compartment and retighten the screw.
