1.
Fix a screw into the desired wall, leaving the head extended out by about 5mm.
2.
Using the Weather Station’s hanging hole, carefully hang it onto the screw.
Note:
Always ensures that the unit locks onto the screw head before releasing.
OUTDOOR TRANSMITTER:
The Outdoor Transmitter is supplied with a holder that may be attached to a wall with the
three screws or double-sided tape supplied. To attach to the wall using screws, please
follow the steps below:
1.
Mark the wall using a pen through the holes in the holder to obtain the exact drilling
position.
2.
Drill holes in the wall at the points marked.
3.
Screw holder onto wall.
The Outdoor Transmitter simply clicks in or out of the holder. When inserting or removing the Outdoor Transmitter to
or from the wall holder please hold both units securely to avoid tearing the holder from the wall.
There is also double sided tape included with the wall holder. On smooth surfaces this can be used instead of drilling
holes. The mounting surface can, however, affect the transmission range. If for example the unit is attached to a piece
of metal, it may then either reduce or increase the transmitting range. For this reason, we recommend not placing the
unit on any metal surfaces or in any position where a large metal or highly polished surface is in the immediate
proximity (garage doors, double-glazing, etc.). Before
securing in place, please ensure that the Weather Station can
receive the 433 MHz signal from the Outdoor Transmitter at the positions that you wish to situate them.
CARE AND MAINTENANCE
:
Avoid placing the units in areas prone to vibration and shock as these may cause damage.
Avoid areas where the units can be exposed to sudden changes in temperature, i.e. direct sunlight, extreme
cold and wet/moist conditions as these will lead to rapid changes in temperature which reduces the accuracy of
readings.
When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents or scouring agents.
Do not submerge the units into water.
Do not make any repairs to the units. Please return them to the original point of purchase for repair by a
qualified engineer. Opening and tampering with the units may invalidate its guarantee.
SPECIFICATIONS:
Temperature measuring range
Indoor
:
0ºC to +60ºC with 0.1ºC resolution
(“
OF.L
” displayed if outside this range)
Outdoor
:
-29.9ºC to +69.9ºC with 0.1ºC resolution
(
“OF.L”
displayed if outside this range)
Indoor temperature checking intervals
:
every 10 seconds
Outdoor temperature reception
: every 5 minutes
Transmitting frequency
:
433.92 MHz
Power source:
Weather Station
: 2 x AA, IEC LR6, 1.5V batteries
Transmitter
: 2 x AAA, IEC LR3, 1.5V batteries
Battery life for both units
:
Approximately 12 months (Alkaline batteries recommended)
Dimensions (L x W x H):
Weather Station
:
86 x 30 x 144 mm (stand excluded)
Transmitter
:
59 x 22 x 65 mm (wall bracket excluded)
