Technogym RUN 600 XTPRO, Service Maintenance Manual

Page: 137 / 158

RUN 600 XTPRO: Service & Maintenance Manual - rev. 1.3
Page 10.1
10. SCHEDULED MAINTENANCE
To keep the machine in perfect working order and prevent the risk of malfunction, it is necessary to
perform the scheduled maintenance operations set out in the table below. There are 3 basic types of
maintenance operations:
•
External cleaning operations;
•
Routine maintenance operations;
•
Special maintenance operations.
The prescribed frequency differs for each type of operation, as does the required level of operator
qualification. The following paragraphs detail the recommended procedures.
10.1. EXTERNAL CLEANING OPERATIONS
These operations can be carried out by the owner of the machine and do not require any
special skills.
The external cleaning operations are involve simple cleaning for the purposes of general hygiene.
These should be performed
at least once a week .
For external cleaning, proceeds as follows:
10.1.1. S
ETTING UP THE OPERATION
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
10.1.2. C
LEANING OPERATIONS
1. Using a cloth moistened with a neutral detergent (non acidic), clean the entire machine, taking
care not to rub too vigorously, especially on the keys of the display.
Never spray the cleaning product directly on the machine.
WARNING: do not use alcohol, petrol or chemical products in general.
10.1.3. L
UBRICATING THE TREAD BELT
1. With the machine powered up but stopped, clean the entire surface between the tread belt and
the running track using a cloth. Repeat several times if necessary.
2. Then lubricate the entire length of the running track and tread belt using the oil that comes with
the service box.
3. Start the machine at a speed of approximately 3 km/h (2 mph) and walk on it, taking care to
tread on the entire width of the belt, so as to facilitate the distribution of the oil on the entire
surface of the belt.