14
Even if the main switch is on, the unit will enter stand-by mode if it remains unused for more than 10
minutes. In stand-by mode, the display is turned off. All you need to do to restart all functions is to
stand in front of the display, where the two presence detectors (
A
) are located.
The product complies with the ERP Directive 2009/125/CE on low energy consumption;
consumption in stand-by mode is less than 0.5 W.
MAINTENANCE
The safety of the equipment is assured only on the condition that it is carefully inspected every two
weeks for any signs of damage or wear. Replace the defective and worn components immediately or
remove the equipment from service.
Call the technical support service for instructions or any maintenance operations not described in this
manual.
The unit should be always kept clean and free of dust, in accordance with standard hygiene and
sanitary practices.
To clean the control panel, proceed as follows:
Turn the unit off by moving the mains switch to position “
0
”.
Unplug the power cable from the wall socket.
Clean the control panel with a damp, yet not wet cloth.
Clean the treadmill completely every week:
When the unit is turned off, clean the external parts with a damp sponge.
Set the running surface at maximum inclination level and use a vacuum cleaner to clean the
underside of the unit.
Clean the running surface with a brush with nylon bristles or a clean synthetic broom, while the
belt is turning with no one using it.
Do not use chemicals or solvents. Do not use abrasive products on polished parts.
Make sure you do not rub too hard on the control panel.
TREADMILL BELT ALIGNMENT
When the belt is running, it must be centrally aligned in relation to the frame. If the running belt tends
to move either to the right or the left, it must be centred.
1. Open the cover flap (
A
) while the belt is stopped.
2. Start the belt at the speed of 3 km/h.
3. Turn the adjustment screw (
B
) located at the rear of the equipment, until the belt is centred.
4. The outer edge (
C
) of the logo on the belt must remain within the marks (
D
) on the casing.
