18
Call: 1-631-648-7481 or Visit: support.technocnc.com
19
HD II Tabletop Manual
NK105G2
Call: 1-631-648-7481 or Visit: support.technocnc.com
HD II Tabletop Manual
NK105G2
Press Menu
Operations
Select
WSC
G54
Origin 1
G55
Origin 2 . . .
WCS
Notes On the G-code File
If a part requires multiple tools, it is best to output a different file for each part.
If the G-code file references a tool number higher than T10, then the controller will give an
error at the start of the file. M6 T1 to M6 T10 are allowed.
In general it is best to remove T commands by telling the CAM package that the machine is
not a tool changer machine, or insuring that the Tool number does not exceed 10.
G92 is the Axis presetting command, when this command is encountered in the G-code file
the XYZ zero position is set at the position the machine is in at that time.
In general it is best to remove this from the G-code file, or if it is in the G-code file, make
sure the machine is at the origin before you press start.
The controller will recognise G54 to G59 offset commands.
See the NK105 G2 manual for more details on these commands.
Acceleration Set
Under the menu MFR Params, there is a sub menu called Velocity.
This menu controls the acceleration and cutting motion of the machine.
The Defaults for these parameters are:
Jerk
310
Single Axis Acc 25
Max Turn Acc
100
A low Max Turn Acc will result in arcs that move in a jerky motion or at a slow speed.
