Technisonic Industries Limited TiL-91-DE/8.33, Installation And Operating Instructions Manual

Page: 12 / 32

3-1
SECTION 3
GENERAL OPERATING INSTRUCTIONS
3.1 INTRODUCTION
This section covers general operating procedures applicable to all base station configurations. Set
Up and Operating details for specific transceiver Models can be found in Section 4.
3.2 Preparation for Use
To prepare the transceiver for use (Refer to Figures 4-1, 4-2 and Table 4-2).
(1) Location for Transmit/Receive Operation.
The VHF frequency band is essentially line of site communication. When selecting an
antenna location there should be no obstacles between the communicating radio sites.
Objects greater than two metres will reflect The RF signal and foliage greatly attenuates
signal strength.
WARNING
Do not make physical contact with antenna when
transmitter is on. This unit can produce up to 10 Watts
of power.
(2) Install Microphone in Microphone (PTT) connector.
(3) Ensure that transceiver POWER ON/OFF switch and the SPG-010 Power supply, AC and
External Battery ON/OFF switches are set to OFF.
(4) Install AC line cord in AC chassis connector on rear panel of the SPG-010 Power
Supply/Charger. Hook-up External Battery to appropriate connector on rear panel of the
SPG-010 Power Supply if required.
(5) Connect antenna connector to rear of transceiver chassis UHF connector.
(6) Connect 9-pin connector for Remote Operation (91-DE Transceiver with 9-pin connector
ONLY).
(a) For Remote Operation Connect appropriate wires to the 9-pin connector provided
on the side of the transceiver. Note: Unit will operate locally and remotely in parallel.
NOTE
Refer to Paragraph 1.3.2 of this document for remote
operation details.
NOTE
The following operating procedures are intended
specifically for Local Operation.
(7) Ensure that the microphone connector is connected to the MIC/PTT connector of the
transceiver.