34
35
10 Pictures and description of the device
Remote controller
MEMORY function
Some of the remote control buttons can be freely programmed. This function allows
to transfer some functions of TV remote control to decoder remote control. Thanks
to this function, user may e.g. switch on the TV set, change volume or choose signal
source.
Programming the buttons with the MEMORY function
>
Press the SET button longer until the red LED on the decoder remote control
lights up solidly.
>
Next, press the button you wish to program on the decoder remote control.
The LED starts blinking.
>
Press the button on the TV remote control that you want to transfer to the
decoder remote control. The TV remote control and the decoder remote
control should be 3-5 cm apart, with their transmitters facing each other.
>
Once the button is programmed, the red LED stops flashing and turns solid.
The remote control is ready to program the next button.
>
Program the next button as described above.
>
Once programming is complete, press the "SET" button briefly. The red LED
stops flashing and the newly assigned button functions are saved.
When programming the buttons, it is very important that the remote controls
are close to each other, with the transmitters facing each other directly. Only
such an arrangement will allow for correct programming.
Device front
1
USB slot (recording, multimedia playback, software update)
2
LED display
3
Buttons. CH-/CH+ channel change, Power - On/Standby
Device back
4
RF input
5
HDMI - output
6
SCART
7
Power cable (AC 110-240V, ~50/60Hz)
4
5
6
7
1
2
3
