7
time. The Multipair-function is standardized deactivated (to en- or disable please see
point 4.2.3.1).
Please take note that this is function is not working with 2 mobile phones at the
same time. Please use a mobile phone and a media player alternatively. Possibly you
need to change the bluetooth settings on your device, for that, please use the corre-
sponding manual.
En- or disable Multipair-function
3.2.3.1.
To
activate
the Multipair-function please proceed as follows:
switch the headset on.
>
push the
>
MFT
as well as the
volume upbutton
for approx. 5 seconds.
after an information sound you can release the buttons.
>
To
deactivate
the Multipair-function please proceed as follows:
switch the headset on.
>
push the
>
MFT
as well as the
volume down button
for approx. 5 seconds.
Release the buttons after the information sound appears
>
To enhance the stability to a Bluetooth device, disabling the Multipair-function will
be suggested.
Connect 2 devices
3.2.3.2.
To establish a connection to two devices, please proceed as follows.
Please connect first to device 1 (see Point 4.2)
>
Switch the Headset off and activate the mode of connection (see 4.2.1)
>
Please set up the connection to device 2 (see point 4.2)
>
Please set up the connection 1 with device 1. (Please consult eventually the manual
>
of device 1)
According to single connections, the connections to two devices will be stored as well
and they reconnect when switch on.
Re-establish connections
3.3.
After setting up connections to a Bluetooth device as described in point 4.2, it is not
necessary to reconnect them when devices are switch on again.
When switching on the StereoManBT (See point 4.1), the last device connect to
will be searched and the connection will be set up again automatically.
If the device is e.g. in Standby mode (because there was no active connection)
you just need to push any button on the headset to re-establish the connection
to the last connected device.
Before reconnection, please make sure, that the Bluetooth function at the
other deivce is switched on.
Some Bluetooth devices request a specific release for an automatic connection (In this