RQT7115
7
Place the unit on a flat and stable surface that is not subject to
vibrations or movement.
Note
•
Do not place this unit on top of amplifiers emitting hot air or place
near spot lights and use for any long duration. This may affect the
unit or disc causing problems.
•
Create space around this unit in order to assist heat release.
•
Place the unit away from televisions and tuners to avoid interfer-
ence. Interference will affect picture and sound quality.
•
Placing the unit near speakers may result in undesired sound in an
environment that requires elevated volume. In this case move the
unit further away from the speaker(s) or turn the volume down.
•
Place stereo phono cables, AC mains lead and panel in a location
that will not be affected by movement or vibration during play.
Undesirable sounds may result if there are movements or vibra-
tions affecting the unit with exception of the legs.
Adjusting the height of the main unit
After placing the unit in the desired location for use, adjust the insula-
tor so the main unit is flat and secure.
Platter setup
Changing the display angle
Change display angle corresponding to position of the main unit.
(
page 11)
Setup
The stoppers are used to lock the platter, protecting the unit from
shock during shipping.
1. Remove the 3 platter lock stoppers from the platter
Turn the platter lock stop-
pers approximately 90
°
Pull the platter lock stop-
pers out
•
Pull out the platter lock stop-
pers once they are aligned with
the release hole.
2. Attach the slip surface (included)
•
With the marker on the slip surface facing up, attach onto the 2
mounting pins.
Store the 3 platter lock stoppers in a safe place after removal.
Adjusting the platter brake
You can adjust the platter brake speed using the BRAKE control on
the rear of the unit. After connecting, adjust to the desired brake speed.
(
page 14)
When transporting the unit
Make sure to re-attach the 3 platter lock stoppers.
1. Remove the slip surface
•
Pack in a way to avoid bending the slip surface.
2. Insert the 3 platter lock stoppers
1. Align the platter holes with the chassis holes inside at the same
position used to remove the stoppers above in step 1.
2. Insert the platter lock stoppers into the holes
•
Move the platter to fully insert the stoppers.
3. Turn the platter lock stoppers approximately 90
°
to lock
Slip surface
Marker
Mounting pin
Platter lock stoppers
