97
8 INTERNET SECURITY
DMS-CTC-20111123-0002 v1.0
Creating your own security level
Proceed as follows:
1 In the
Toolbox
menu click
Firewall
.
2 In the
Firewall
section, go to the
Configure
page.
3 In the
Pick a task
list, click
Create a new Security Level
.
4 In the
Name
box, type a name for the new security level and select an existing security level to clone from.
5 Click
Apply
.
6
A page with the firewall settings of your newly created security level appears. Click
Edit
.
7 Enter the following information:
The
Name
of the firewall rule.
The
Source Interface
and
IP Address
(range).
Or you can type a
User-defined
IP address (range).
The
Destination Interface
and
IP Address
(range)
Or you can type a
User-defined
IP address (range).
The
Service
type of the traffic; this can be a protocol (DNS, SMTP,...) or a specific MediaAccess Gateway system
service.
8 Select an
Action
that should be done on traffic for which the firewall rules applies:
Accept
: to allow the traffic to pass
Deny
: to drop the traffic (without notification)
Count
: to let the traffic pass, but count it (Hits)
9 Click
Apply
.
Once you create a security level, you can not delete it anymore. It will always available in the list of available security
levels.
Use
Any
as IP address in case all traffic for the interface should be parsed.
Use
Any
as IP address in case all traffic for the interface should be parsed.
Summary of Contents for TG650S
