13
(1) Basic wiring diagram for group control
This diagram shows when several units (max. 8) are
controlled by a wired controller. In this case, a
wired controller can be connected at any indoor unit.
NOTE
●
R.C. Addresses should be set before turning the power on.
●
Auto. address setting can be executed by the wired controller automatically.
Please refer to section 7 “PCB Setting”.
●
Each successive unit will respond at one-second intervals following the order of the R.C. (S2) address when the remote
controller is operating.
Indoor Unit
Inter-unit
control wiring
(Low voltage)
Inter-unit
power wiring
(Line voltage)
Inter-unit
control wiring
(Low voltage)
Inter-unit
power wiring
(Line voltage)
Outdoor Unit
Indoor Unit
Outdoor Unit
*1
R.C. Address on the PCB:
PCB: 1 (S2, BLK)
Power supply
380 - 415 V - 3 N
~
50 Hz
R.C. Address on the PCB:
PCB: 2 (S2, BLK)
Power supply
380 - 415 V - 3 N
~
50 Hz
Ground
Ground
Ground
Ground
Inter-unit
control wiring
(Low voltage)
Inter-unit
power wiring
(Line voltage)
Indoor Unit
Outdoor Unit
R.C. Address on the PCB:
PCB: 8 (S2, BLK)
Power supply
380 - 415 V - 3 N
~
50 Hz
Ground
Ground
Wired controller
(option)
RED
WHT
BLK
E
E
EG
