11
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
●
The activated carbon air filter is to be added by springs
to the standard filter.
●
It is made of two layers:
- the first layer consists in a synthetic honey comb high
efficiency media to remove the dust and purifing the
air.
- the second layer in charcoal media deodorizing the
ambient air.
ACTIVATED CARBON AIR FILTER INSTALLATION
PROCEDURE
1.
Open the unit intake air grille and pull out the standard
air filter.
2.
Apply on the rear side of the filter the two spings supplied
with the accessory.
3.
Fix the activated carbon filter by the springs.
4.
Insert the two air filters one over the other and close
the intake grille.
REAR SIDE OF
AIR FILTER
SPRING
ACTIVATED CARBON
FILTER
1.
Remove the screw on each side out of the latch using a
screwdriver.
2.
Press on the two latches of the air intake grille with your
thumbs in the direction of the arrow to open the grille.
3.
Open the air intake grille downward.
4.
Remove the air filter from the air intake grille.
5.
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm, soapy
water, rinse it in clean water, and dry it.
3.
Insert the filter correctly again inside the grille, close the
grille letting the latches slide toward the outside and fix
again the latch with the screw on both sides.
The air filter should be cleaned at least once every six
months or more frequently; it depends on the real operation
conditions.
HOW TO REMOVE THE FILTER
L AT C H
SCREW
AIR INTAKE GRILLE
AIR FILTER
CWX MODELS
HOW TO REMOVE THE FILTER
1.
Grasp both ends of the air intake grille and pull to open
it.
2.
Hold the air filter by the tab and pull it upward. Clean the
air filter.
3.
When replacing the filter, make sure that the FRONT
mark is facing you. Reinsert the filter into place and close
the air intake grille.
KPSW MODELS
ACTIVATED CARBON AIR FILTER
(ACCESSORY SUPPLIED ON REQUEST)
MCW MODELS
The activated carbon air filter removes dust and dirt from
the air, and reduces odours and smoke from tobacco.
This activated carbon air filter cannot remove harmful gases
or vapors nor ventilate air in the room. You must open doors
or windows frequently when you use gas or oil heating
appliances. Otherwise there is a risk of suffocation in an
extreme case.
NOTE
1.
Two activated carbon air filters for one indoor unit are in
this polyethylene bag.
2.
Open the bag just before installing the activated carbon air
filters, if not the deodorizing effect durability of the filter may
be decreased.
ACTIVATED CARBON AIR FILTER INSTALLATION
PROCEDURE
The activated carbon air filter needs to be installed behind the
air filter.
1.
Remove the air filter.
2.
Install the air clean filter in the position shown in the figure
with the symbol "FRONT" facing you.
3.
Reinstall the air filter.
Activated carbon
air filter
Activated carbon
air filter
Front: white
Rear: black
REPLACEMENT OF ACTIVATED CARBON AIR
FILTER
•
The filter is disposable.
•
Do not throw away the filter frame.
•
The used filter cannot be reused even after cleaning up.
•
Obtain the filters for replacement at your nearest dealer.
•
Check the state of dirtiness at least once every two weeks.
•
Replace the filter after six months’ operation.
WARNING
KPSW MODELS
FRONT
3
2
1
GB
