8
VERTICAL (with remote control unit)
The remote control gives you the possibility to control the
flap in two way:
1. Push the button to start the flap sweep. If you
push again the flap stops immediately.
2. Push the button to move the flap step by step.
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
ADJUSTING THE AIR FLOW DIRECTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
CAUTION
Left
Vertical vane
Right
NOTES
Sweep function
The flap starts
moving up and
down to deliver air
over the sweep
range.
• The flap automatically closes when the unit is off.
• During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
Up
Down
Flap
Air outlet
grille
VERTICAL VANE
FLAP
Zone «A»
for cooling and dehumidifyng
Zone «B»
for heating
40°
50°
40°
50°
« B »
« A »
« B »
HOW TO ADJUST THE FLAP DIRECTION
KPSW MODELS
« A »
MCW MODELS
CWX MODELS
FLAPS
(ONLY MCW- KPSW)
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
CAUTION
MCW MODELS
KPSW MODELS
GB
