8
Power
Power is connected to the fixture with an IEC power inlet and cord.
Before applying power to fixture, verify input voltage matches the power
source voltage. Check all power cords to verify they are of proper type
and sufficient rating for the equipment attached. For protection against
electric shock, fixture must be connected to suitable earth ground. The listed
current rating is its average draw under normal conditions. All fixtures must be
powered directly from a switched circuit. This fixture cannot be run on rheostat
or dimmer circuits - even if used solely for a 0% to 100% switching. Consult a
qualified electrician if there are any concerns about proper connection to power.
Note: After a few seconds of powering this fixture, it will begin its reset function.
Voltage Selection
This Fixture is equipped with an Auto Switching Power Supply. It will automatically adjust to any
line voltage within the specified range.
LED Engine
This unit is equipped with 7 Long Life LED RGBW Engines that are aligned at the factory.
There is no need for the user to change lamps or perform any alignment.
Do not stare directly into the light source.