INSTALLATION in 4 steps
Pre-Installation
Before starting with mounting and removing cover off your car,
check to make sure that the vehicle is safely parked and that ALL
electrical components are switched OFF. Clean the bumper
thoroughly and dry it with clean clothes. Ask a fried or a family
member to assist you. This will make the installation much easier.
READ THE INSTRUCTION FIRST, BEFORE INSTALLING THE
SYSTEM, prepare the following listed equipment:
Drill & Drill bits, Measuring tape, Pencil & Marker, Plier & Screw
driver, Electrical tape, Multimeter voltage tester, Steel wire,
Sandpaper.
1. Mark the position of the sensors
Measure and mark the vertical position (center line) according to
diagram 1. Ensure that the position is above 50cm (ideally 55cm)
from the ground surface.
NOTE:
It must be directly vertical.
Diagram 1
