Repeat this process for all remaining sensors, one at a
time. Once you are satisfied that everything is working, plug all
sensors to their corresponding slot in the Control Box. Do a final
check to ensure that everything is correctly plug into its right
position.
Shift the gear back to
“Parking” for automatic vehicles
and remove the vehicle’s key. Car holders with gearshift just
remove the vehicle’s key.
Finish the installation
Fix the Control Box to its final position. Ideally it should be in a
dry, clean and protected area. We suggest to place and fix steadily
the Control Box in the trunk of your vehicle, depending on the side
you connected the power cable with the reverse light.
Fix the Display to its final desired position. We suggest
mounting it
with the 3M sticker to the car’s dashboard. Find a good
position for you to read the display clearly. Hide all cables and
wiring for a clean installation.
SPECIAL NOTE
Check the conditions behind your car before (!) reversing.
In some special cases, the display may not be the same as the
real condition due to the sensor position, obstacle shape, reflection
condition and so on.
Here some examples:
In case of small angle of incidence to the obstacle, such as Glass or
other smooth plane, the obstacle may not be detected as the
signals are reflected away.
