·
Important safety notice
Please read below safety instructions carefully before installation
and operation:
1. Please pay attention to all the warnings and hints on this device.
2. Do not expose this unit to rain, moisture and liquid.
3. Do not put any stuff into the device.
4. Do not repaire the device or open the enclosure without professional
person guidence to avoid electronic shock.
5. Make sure good ventilation openings to avoid product overheating
damage.
6. Shut off power and make sure environment is safe before installation.
7. Do not plug-in/out the network cables and IR cables when it is in
using to avoid cables damage.
8. Use DC5V3.5A only. Make sure the specification matched if using 3rd
party DC adapters.
·
Introduction
This transmitter extends HDMI signal wirelessly from source device to
display device up to 200meters with the advanced application of
HDbitT transport protocol and wireless technology. The signal
resolution up to 4Kx2K@60Hz. It requires no cables between sender (TX)
and receiver (RX) which makes the installation easy and clean.
Note:
1) Transmission distance will be different due to the environment.
2) Wall, brick or glass will shorten the signal cover range or cause big
signal loss.
·
Features
1. HDMI 2.0 and HDCP2.2 compliant
2. Extend HDMI signal wirelessly
3. Strong anti-interference ability by running at
5.1~5.8GHz operation frequency
4. 200m long transmission distance
5. High resolution up to 4K×2K@60Hz ultra HD
6. IR passback with 20-60KHz wide frequency to control source device
from receiver side easily
7. Support point to point and point to multi-point configuration
(1 TX to 2 RX)
