techem radio frequency smoke alarm 2, Operating Instructions Manual, Page: 20 / 218

20
!
After the fault cause has been rectified, press the user key and remove yourself
from the RWM within a period of 10 seconds to allow the fault message to be
switched off on the RWM.
If rectification of the fault cause is not possible, please call the Hotline: 0800 2 00
1264
(free of charge) as soon as possible.
For safety reasons, keep the doors to rooms with functional RWMs open until the
fault has been rectified.
The activation of environmental monitoring is signalled as follows:
Signal sound Red LED
2 short signal tones every 10 minutes Flashes twice every 30 seconds
This is how the surroundings monitor signal tone is turned off for 3 days:
User key Signal sound Red LED
Press the user key until a short
acknowledgement tone sounds Short acknowledgement tone Flashes twice every 30 seconds
After deactivation for 3 days has been made three times, deactivation is then only possi-
ble for one day at a time.
Fault/ Damage
!
In case of a fault with, or damage to, the RWM, the device must be replaced as
soon as possible. Please immediately contact the Hotline: 0800 2 00 1264 (free of
charge).
Do not attempt to repair defective RWMs. There are no exchangeable parts (e.g.
batteries). For safety reasons, keep the doors to rooms with functional RWMs
open until the defective RWM has been replaced.
Failure is signalled as follows:
Signal sound Red LED
3 short quiet signal tones every 5 minutes Flashes once every 5 seconds
This is how the surroundings monitor signal tone is turned off for 3 days:
User key Signal sound Red LED
Press the user key until a short
acknowledgement tone sounds brief acknowledgement tone Flashes once every 5 seconds
After deactivation for 3 days has been made three times, deactivation is then only possi-
ble for one day at a time.