5
5.
SETUP INSTRUCTIONS
Refer to Figure 3.0
Note: This installation uses Luer lock adapters shipped with the valve.
1.
Connect the fluid feed tube or syringe to the fluid inlet port (1).
2.
Connect the valve airline to the valve controller or other pneumatic device
that is used to control the valve.
3.
Connect the opposite end of the airline to valve air inlet (2).
4.
Connect appropriate dispensing tip or nozzle to the fluid outlet port (3).
5.
Set the valve controller pressure at
70 psi (4.8bar)
.
6.
Set the fluid pressure.
Do not exceed 60 psi (4.1bar)
.
7.
Make sure all connections are tight.
8.
Place container under the outlet and activate the valve until the fluid flows
steady.
The amount of fluid that flows through the valve is determined by:
Valve open time
Fluid reservoir pressure
Dispensing tip size
Stroke adjustment knob position
Figure 3.0
1
3
2
