13
14
High-middle-low
speed switch
One-key return
GPS switch
Throttle Joystick
Headless mode
Power switch
Direction Joystick
Left-right fine tuning
Front-back fine tuning
Video
Photo
One-key take off/
One-key landing
Memory card installation
Memory card
Video
Photo
Camera angle adjustment
NOTICE:
1.This function only can work in GPS mode.
2.The one-key return function brings the drone back to the last recorded Home Point.But there
is a distance deviation of 1~2 meters.
3.When the Flight Battery level is low,the drone will fly back.
4.The drone will return if the signal to the transmitter is lost.
GPS Switch
Press GPS switch on the transmitter to exit GPS mode, Please exit GPS mode while operating indoor as
signal is weak. Turn on the drone and transmitter and press the GPS button once it is paired.
Assemble the Memory Card /Camera Angle Adjustment
1. Install the memory card: correctly insert SD card into SD card slot on the bottom; press it lightly,
insert SD card, and press it again to automatically pop up the SD card.
(SD card does not include)
2. Camera of drone can be adjusted manually with the amplitude of 0°-35°;
As adjusting the lens, do not contact with the lens on the camera. Otherwise, it will affect
image quality.
Notice:
3. When the transmitter is connected with the drone, use a mobile phone to connect with WiFi signal to
enter into APP control interface; as taking a picture, press the key to Photo button for once; then,
mobile phone will give out a sound of “ka”, and it takes a picture. The picture is directly stored in
mobile APP file.
4. After the transmitter is connected with the drone, use the mobile phone to connect with the drone’s WiFi
signal to enter into APP control interface; as taking a video, press the video button; there is recording
time at the camera shooting icon in mobile phone; press video button to finish recording and maintain it in
the mobile phone file.
①
②
③
Mobile Phone Installation
1.Align the mobile phone clamp to the remote control and install it vertically in place.
2.Pull out the phone holder and lock the phone as shown below, adjusting the phone to avoid clipping
the phone buttons.