5
6
Video
Video
High-middle-low
speed switch
One-key return
Photo
Photo
(meanwhile press down)
U
S
B
Cellphone
charger
Power
bank
Computer
Car
charger
NOTE:For faster charging,it is recommended to use a
5V 2A AC Adapter(not enclosed)to charge the battery.
Charging the Battery
(meanwhile
press down)
LCD Display Icon Functions
1.GPS Indicator light
2.Return
3.Low power
4.Headless Mode
5.Compass Indicator light
Emergency stop
1. The transmitter uses four 1.5V/AA batteries. The positive and negative electrodes of the
battery cannot be reversed.
2.Please pull out the batteries if the transmitter isn’t used for a long time.
Notes:
Installation Method of Transmitter Batteries
Use a screwdriver to open the battery cover in anticlockwise rotation, install batteries to the battery box, lid
the battery cover, and lock the screw on battery cover.
The transmitter uses
four 1.5V/AA batteries.
1. Connect the drone batteries with USB charging cable, connect USB charging cable with any mode of
charging USB in the figure (give priority to 5V 2A charger for charging).
2. When batteries are charging, USB indicator’s red light is bright. When it is fully charged, indicator puts out.
The charging time is about 150min.
Drone Battery
One-key take off/
One-key landing
1.Failure to follow all the instructions may result in serious injury, irreparable damage to the battery and
may cause a fire, smoke or explosion.
2.Always check the battery’s condition before charging or using it.
3.Replace the battery if it has been dropped, or in case of odour, overheating, discolouration, deformation
or leakage.
4.Never use anything other than the approval LiPo charger the battery. Always use a balancing charger for
LiPo cells or a LiPo cell balancer. It is recommended that you do not to use any other charger than the
one provided with the product.
5.The battery temperature must never exceed 60°C(140°F) otherwise the battery could be damaged or
ignite.
6.Never charge on a flammable surface, near flammable products or inside a vehicle (perferably place
the battery in a non-flammable and non-conductive container).
7.Never leave the battery unattended during the charging process. Never disassemble or modify the
housing’s wiring, or puncture the cells. Always ensure that the charger output voltage corresponds to
the voltage of the battery. Do not short circuit the batteries.
8. Never expose the LiPo battery to moisture or direct sunlight, or store it in a place where temperatures
could exceed 60°C(car in the sun, for example).
9.Always keep it out of reach of children.
10.Improper battery use may result in a fire, explosion or other hazard.
11.Non-rechargeable batteries are not to be recharged. Rechargeable batteries are only to be charged
under adult supervision.
12.Different types of batteries or new and used batteries are not to be mixed.
13.Batteries are to be inserted with the correct polarity.
14.The supply terminals are not to be short-circuited. Regular examination of transformer or battery charger
for any damage to their cord, plug, enclosure and other parts and they must not be used until the
damage has been repaired.
15.The packaging has to be kept since it contains important information.
16.The toy is only to be connected to Class II equipment bearing the symbol.
Fixed
Propeller
BATTERY WARNING:
1.Unscrew the small screw, pull out the propeller.
2.Unscrew the 2 small screws of the LED light cover, pull out the cover.
3.Hold up the tube, attach the correct propeller.
4.Keep the propeller in place, tight the small screw.
5.Put the LED light cover back and tight the 2 small screws back.
Please be careful to avoid falling the screw into the gap.
Replace and Attach the Propellers
