l) If you are interrupted when operating the drill, complete the process and switch off before
looking up
m) Where possible, use clamps or a vice to hold your work
n) Examine the chuck regularly for signs of wear or damage. Have damaged parts repaired by a
qualified service centrer) ALWAYS wait until the drill has com
o) ALWAYS wait until the drill has come to a complete stop before putting it down
p) Periodically check all nuts, bolts and other fixings and tighten where necessary
Battery Safety
WARNING:
Li-Ion batteries, if incorrectly used, stored or charged are a fire, burn and
explosion hazard.
- Keep the battery out of reach of children
- ONLY charge Li-Ion batteries using the charger provided or designed specifically for your product
- ONLY use Li-Ion batteries provided with a product or specifically designed to be compatible
- Allow batteries to cool for 15 minutes after charging or heavy use. Failure to follow these
instructions may cause overheating or fire
- When not in use batteries should be stored at room temperature (approximately 20˚C)
- Ensure that battery contacts cannot accidentally short in storage. Keep batteries clean; foreign
objects or dirt may cause a short. Keep away from other metal objects, for example, paperclips,
coins, keys, nails and screws
- Under abusive conditions, liquid may be ejected from the battery. This liquid may cause skin
irritation or burns. Avoid contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, seek medical help
- DO NOT open, disassemble, crush, heat above 60°C or incinerate. Do not dispose of in fire or
similar
Battery Charger Safety
Use the battery charger correctly
- Refer to the section of this manual relating to use of the battery charger before attempting to
charge the battery.
- Do not attempt to use the charger with any batteries other than those supplied. Keep your
battery charger clean; foreign objects or dirt may cause a short or block air vents. Failure to
follow these instructions may cause overheating or fire
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard
WARNING: DO NOT attempt to recharge non-rechargeable batteries.
Before Use
Removing a battery
7
- -
