- Use a countersink bit to remove sharp burrs from the hole, preventing cuts and other kinds of
injury
WARNING:
If the power tool gets excessively hot in use, stop using the tool immediately and
allow to cool before continuing work. The cooling period can be reduced by operating the drill at
maximum speed with no load. Always make sure the Motor Vents (4) are not blocked and do not
allow dust to enter the body of the tool through the Motor Vents; dust, especially metallic dust,
may damage or destroy the tool.
Install Belt Clip
The Belt clip is convenient for temporarilyhanging the tool.
This can be installed on the tool.To install the belt clip,install
it into a groove in the tool housing and then secure it with a
Screw.To remove loosen the screw and take it out.
Maintenance
WARNING: ALWAYS disconnect from the mains power supply, before carrying out any
maintenance/ cleaning of the charger. Remove the battery before carrying out any maintenance/
cleaning of the drill.
Note: Both the drill and the charger contain no user-serviceable parts. If the device does not
perform as outlined in this manual, return it to an authorised GMC service centre for repair
General inspection
- Regularly check that all the fixing screws are tight
- Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised service centre. This advice also applies to extension cords used with
this too.
Cleaning
- Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine’s service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
- Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol
or strong cleaning agents
- Never use caustic agents to clean plastic parts
Lubrication
- Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Storage
- Store this tool carefully in a secure, dry place out of the reach of children
10
12
- -
