TEC TEC EO1-32004, Owner'S Manual

Page: 89 / 94

14. ERROR MESSAGE TABLE
14. ERROR MESSAGE TABLE
14- 3
●
CMT Operation Mode
●
LON System Mode
M: Master terminal BM: Backup master terminal S: Satellite terminal
Message Cause Solution
Mismatch of the model type.
Mismatch of the base unit.
Mismatch of the VERSION.
Mismatch of the
TRANSMITTING DATA.
MISMATCH SCALE SPEC
Mismatch of the scale capacity.
Press the key.
Parity error
Framing error
Overrun error
Data error
BAD TAPE OR CMT
Two or More Hardware error
Press the key.
TIME OUT ERROR Time out error Press the key.
Error message Cause Solution M BM/S
COMMUNICATION
ERROR 1. The power of the master or
backup master terminal is not
turned ON.
They are not connected with
each other or in off-line state.
2. LON cable is broken.
1. Turn the power of the master
or backup master terminal
ON.
Connect them with each
other or turn the terminal in-
line.
2. Call your authorized service
representative.
○ ○
SEQUENCE ERROR The power was not turned OFF and
ON again after setting ID #. Turn the power switch OFF and
ON again.
○ ○
SEQUENCE NO.
ERROR Text data number is incorrect. Call your authorized service
representative.
― ○
MASTER BUSY Registration job is performed on a
satellite terminal while reset job is
performed on the master terminal. 1. Quit reset job on the master
terminal.
2. Quit registration job on the
satellite terminal.
― ○
BACKUP MASTER
NOT RESET The backup master does not have
same PLU with the master terminal. Down load PLU from the master
to the backup master terminal.
Then run the reset operation
again.
○
―
TEXT ERROR ## 1. Error text is found.
02: Sequence No. error
05: LRC error
08: Text error
09: Command error
2. The master terminal differs from
other terminal in ROM version.
Call your authorized service
representative.
○ ○
CLEAR
CLEAR
CLEAR