6-29
EM18-33017
6. DIAG. TEST OPERATION
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1
D I A G N O S T I C
V 1 . O A
>
Press the [FEED] key.
< 2
P A R A M E T E R
S E T
>
Press the [PAUSE] key ten times.
Select either ribbon type with
the [FEED] key or [RESTART]
key. (See NOTE 1and 2.)
Press the [RESTART]
key. (See NOTE 3.)
R I
B O N
T R A N S .
B
Press the [PAUSE] key.
Continued on Section 6.3.10
Ribbon Motor Drive Voltage
Fine Adjustment.
NOTES:
1.
Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
enables a fast forward.
2.
Non-transmissive (NON TRANS.) ribbon cannot be used so the ribbon type must
be set to transmissive (TRANS.) ribbon.
3.
A change ribbon type is stored in memory by pressing the [PAUSE] key.
•
Transmissive ribbon
Transmissive:
With ribbon
Non-transmissive:
Ribbon end
•
Non-Transmissive ribbon
Transmissive:
Ribbon end
Non-transmissive:
With ribbon
6.3 PARAMETER SETTING MODE
6.3.9
Ribbon Type Selection
