- 80 -
EO3-11070
MA-1650-4 SERIES
NOTES:
1. The “Address Nos” designation at the top after “3 [X]” can be skipped if not necessary. If entered,
the designated Address(es) will automatically be accessed after the department designation. For
example, if you enter |0204| [#] here (designate each address by entering a two-digit code; 01
for Address 1, 02 for Address 2, etc.), you will then enter:
[DEPT] key , or Dept Code + [DP#] key,
Character Entries [ST] (“2 [ST]” can be skipped), then
Status Codes [#] (“4 [ST]” can be skipped), then
may go on to another department setting for the same address designations.
But still in this case, you can go to other addresses by first entering the Address No. and
depressing [ST]. The Address Designation feature may be useful when you want to program or
change contents of only one or two specific Addresses of multiple departments. (For example,
when you want to change only the names, but not any other programmed contents, of 15
departments.)
2. The “[DEPT]” key here means each of the individual department keys of Dept Preset-code type.
For example, if you have [DEPT 1] (Department No.1) key, you can depress it, or you may enter
1 then depress [DP#] to start Department No.1 programming procedure. You can only enter the
Dept Code and then depress [DP#] to start any other department than those installed as Dept
Preset-code Keys. When you use a Flat Keyboard and the Setting Mode Key Layout sheet is
inserted, any department may be accessed by using the [DP#] key in the SET mode operations.
Up to 99 depts can be programmed. The [DP#] key should be used to program depts 61 to 99.
(In SFKC programming, up to 60 depts can be programmed.)
3. When the Address No. is sequential from the preceding address (and when the Address
Designation feature has not been used), the Address No. and [ST] may be omitted.
4. The programming contents of each address are further described in the DEPARTMENT
PROGRAMMING CONTENTS below.
DEPARTMENT TABLE PROGRAMMING CONTENTS
1
Linked Group Code
Enter a 4-digit code, composed of a 2-digit Major Group Code and a 2-digit
Minor Group Code.
[#]
Minor Group Code 01 to 30
Major Group Code 01 to 10
ex.)
To link Major Group No. 1 and Minor Group No. 1:
Enter:
(0) 1
0 1
Enter 00 when the department is not
linked to any Minor Group.
Enter 0 (or 00) when the department is not linked to
any Major Group.
-- Continued on next page --
Major Group
Code
Minor Group
Code
Address No.
Description of Programming Contents
