TEC B-443, Service Manual

Page: 44 / 76

November, 99 All Rights Reserved 41
B-443 Bar Code Printer
Service Manual
4.6 Stepping Motor Replacement
1. Turn off the printer power.
2. Remove the power cord and RS-232 and/or Parallel port cable.
3. Open the top cover of the printer.
4. Remove the printer front panel. (Cf. Fig. 3.14)
5. Remove the two screws and the metal cover. (Cf. Fig. 3.15)
6. Release the cable tie and remove the peel-off sensor connector. (Cf. Fig. 3.16)
7. Remove the screw on the PCB of peel-off and cutter connector.
8. Remove the screws in the lower left, lower right corners of the main mechanism. (Cf. Fig.
3.17)
9. Remove all four screws of the internal label roll mount. (Cf. Fig. 3.18)
10. Move the mechanism in the label feed direction about 5 mm.
11. Take out the internal label roll mount and remove the connector. (Cf. Fig. 3.19)
12. Remove the screw of ground wire on the mainboard.
13. Remove all the connectors on mainboard. (JP1, JP2, JP3, JP4, JP5, JP6, JP7, JP11, JP7,
JP9, JP12)
14. Take out the mechanism.
15. Remove the two screws of the stepping motor.
Fig. 4.9 Stepping Motor
16. Replace the stepping motor, stepping motor wires, and reassemble the removed parts in the
reverse order of removal.