Technical manual of
FanControl-U2 module
6
Switch the module on/off with the external input
Status control
*
12V
0V
Оn
Off
Input #11
FanControl
*
To restart the module via input #11 it is necessary to switch off the “status” signal and then
activate it again.
Trigger control
12V
0V
Input #9
FanControl
On
Off
Programming sequence
1.
Choose required option in table 3. Then press PB amount of times corresponding to menu
code. LED will inform you about it’s state.
2.
Change option state. To do so press PB required amount of times, required to change the
option value to the chosen one. Mind that the first value, goes after last value.
System will leave programming mode and save all changes after turning off the ignition or
after 15 seconds after last button press. LED will flash 4 times if settings are saved succesfully
or 1 time if there is an error during save.
Table 3. System setup
Menu
Menu
code
Factory
default
Note
Protocol
W-BUS/Eberspächer
6
1
Set automatically. Choose by hand if required.
1 – Automatic identification; 2 – Webasto;
3 – Eberspächer;
4 – Protocol control is forbidden;
5 – Factory Webasto heater alternative protocol
for VAG;
6 – Factory Webasto heater for RR Evoque
(2011-2013);
7 – Factory Eberspächer for RR Evoque (2011-
2013)/Sport (2014-2015);
8 – Factory Eberspächer for Toyota;
9 – Factory Eberspächer for RR Sport (2016)
The vehicle battery
voltage level for automaic
system shut down
11
9
1 — 10,5 V; … 9 — 11,3 V; ... 11 — 11,5 V
Heater operation time
10
3
1–10 min; 2–20 min; 3–30 min; … 12–120 min
Supplementary (auxiliary)
heater mode
12
2
If outside temperature is lower 5°C — an
aftermarket heater will start automatically. If
outside temperature increases to 12°C —
heater will turn off.
1 — on; 2 — off
Climate sytem control
algorithm
14
1
1 — standard
;
2 — alternate algorithm №1
*
;
3 — alternate algorithm №2
*
;
4 — alternate algorithm №3
*
Aftermarket heater
temperature limiter
*
15
1
1 — disabled; 2 — 71°C; 3 — 73°C; … 9 — 85°C
Climate control setup
*
20
1
1 — enabled; 2 — disabled
Climatic system settings
24
1
1 — Activation immediately after a heater
is turned on
2 — Delayed activation after a heater is turned on
3 — Activation by temperature
4 — Activation after a delay or by temperature
(depending on what comes first)
5 — Climatic system inactive
