Teamline 5250
Page 21
Installing the VHD-V61 camera
n
The installation must be performed by qualified service personnel or system
installers in accordance with all local rules
n
Do not move the camera head manually. Doing so results in the camera
malfunctioning
n
Before powering the camera, check the power voltage carefully. Ensure
you are using the correct power source
n
Ensure that the camera is far away from areas where there might be
radiation, x-rays, or strong electric waves, or where magnetism is generated
To install the camera:
1. Connect the supplied HDMI-HDMI cable to the HDMI connector on the
camera. Connect the other end to the Camera-In HDMI connector on the
Teamline system.
2. Connect the supplied VISCA camera control cable to the RS-232 IN
connector on the camera. Connect the other end to the VISCA connector
on the Teamline system.
3. Connect power to the DC 12V power input on the back of the camera.
Note:
The selector switches on the rear of the camera have no effect on the
operation of the camera.
Mounting the camera upside down
VHD-V61 cameras can be mounted upside down if the camera meets the
following minimum requirements:
Software version
SOC v7.2.08 – ARM v6.2.50SF
Webware version
v1.4.4
To use upside down mounting, the camera image must be flipped.
To flip the image:
1. Ensure the camera is connected to the room display with the HDMI cable.
2. Connect an Ethernet cable from your computer to the LAN port on the
camera.
3. On the label on the base of the camera, note the IP address. For example:
