Team SILK FXB630, Instruction Manual

Page: 28 / 76

FXB630 Flange Facing and Grooving Machine
27
WHEN USING THE DTI TO SET THE MACHINE PARALLEL ALWAYS FIT THE
SETTING STRAPS TO THE BASE ASSEMBLY. IF THIS IS NOT POSSIBLE
CARE SHOULD BE TAKEN TO SUPPORT THE MACHINE ADEQUATELY
DURING THIS PROCESS
If a greater degree of accuracy is required, for example when re-machining a 'V'
groove. Remove the nylon location spigot from the bottom of the machine before
mounting onto the base assembly in the bore. Lightly secure the machine with the
three shouldered bolts allowing the machine to be moved with a sharp tap from a
hammer and soft drift but also maintaining the new position until it is finally centred
to the groove.
IT IS RECOMMENDED THAT ONLY THE HARDENED COLLAR AT THE BASE
OF THE MACHINE IS STRUCK WITH A SOFT DRIFT.
REFER TO SECTION 3.1 AND FIT THE FALL-STOP KIT OR SIMILAR DEVICE IF
REQUIRED.
CHECK THE BASE ASSEMBLY IS SECURE BEFORE REMOVING THE
SETTING STRAPS
5.2.4 Balancing the machine (vertical use)
Fig. 14 Adding balancing weights
Mounting
bar
Main counter
balance weight
Auxiliary counter
balance weight