35
PROBLEM
ACTION
Data cannot be transmitted to the
printer.
Make certain the printer cable is securely connected to the back
of the printer and computer.
SCSI Interface:
Verify the SCSI ID is not conflicting with other device(s).
Cycle the power by turning the printer off and then back
on.
Verify the position of the terminating switch. The
terminating switch should be in the on position if the
printer is at the end of the SCSI chain and off in all other
positions.
Parallel Interface:
Cycle the power by turning the printer off and then back
on.
Setting the Parallel Port to ECP
You must change the parallel port mode through your system
"BIOS" or setup screen. The system BIOS is generally entered
by holding down a specific key while the computer is booting
up. This key will differ depending on which brand of computer
you have, but is often specified on screen during initial startup.
For example, a line such as "Press <DEL> key if you want to
run SETUP‖ may appear.
Once you have entered the BIOS, use the on-screen directions to
locate the parallel port option and change it to ECP. Also, check
if your particular BIOS provides an option for enabling a DMA
channel. If so, enable this as well. Once changed, save the
BIOS settings and reboot.
Nisca Print Spooler Error
Ensure ―Enable bi-directional support‖ is activated.
4.5 Where to get additional help
If you work with an authorized Nisca distributor or value added reseller, contact your reseller for
assistance. You may also contact us at one of the following sources:
Telephone:
(732) 271-7367
Sales email:
Technical Support email:
Website:
www.teamnisca.com
Summary of Contents for Nisca PR5300
Page 2: ......
