OSD Menu
When you open the OSD menu by holding the button for 3s or by the stick command (throttle down, yaw
left for 3s)
General:
●
Data port:
CRSF/ SA/ PWM Switch
- Input protocol used on port 1
●
Ext. Port:
C.Sensor/ Off
- Not yet used
●
OSD:
White/ Black/ Off
- Change the font color or disables the OSD
●
OSD Level: Adjust if the OSD disappears in bright or dark areas
●
GPS:
Basic/ Detail/ Off
- GPS information detail level
●
Heading Source:
GPS/ YAW
- Source for heading estimation. GPS is only recommended for wings
●
Mic En.:
On/ Off
- Enable/ disable the build- in microphone
●
Barcode:
Enable/ Disable
- Use the barcode quick setup
VTX
●
Band:
A/ B/ E/ AIR/ RACE/ USER
- Band selection
●
Channel:
1-8/ User Frequency
- Channel/ Frequency selection
●
Power:
25/ 100/ 400/ 800mW
- Output power selection
●
Temp. Limit:
60/ 70/ 80/ 90/ 100/ 105
- Temp. limit when the output power will be lowered
●
Pitmode:
Enable/ Disable
- Toggle Pitmode
Callsign
●
Enter your call sign here
Channel Map
●
Stick Menu : Enables/ disables stick control
●
Channels : Setup for stick control
●
Pitode : Channel used to toggle Pitmode by switch (if not enabled by the
VTx
menu!)
In-Build voltage sensor
When the Unify Evo does not detect an external voltage sensor, it will fall back to VIn voltage monitoring.
If your voltage shows a lower voltage (e.g. 5.0v), check the setting for the Crossfire/ Tracer voltage sensor
and deactivate it (
CRSF Menu/ Receiver/ General/ Voltage Sensor -> Off)
13
