Mounting your HANDEMAN XTRA®
Suitable for both external and internal use, the unit should be
mounted on a suitable vertical surface with sufficient clearance to
allow full use.
1.
Use the four bolts holes provided.
2.
Remove the waste-safe® water tray by lifting vertically and
then pulling towards you (see attached drawing).
Electrical Connections
Check that voltage of the vehicle is correct for the unit supplied.
Follow the approved electrical practice when installing the unit.
Before installation, isolate the –ve earth battery terminal.
All wiring must be 4mm² Ø
56/0.3 rated 40 amps and protected
from sources of abrasion and heat. The use of plastic conduit
BS6231 and Tri rated cable is recommended.
* Red wire:
To +ive battery terminal using the 30 amps
fuse for 12V or the 15-amp fuse for 24V as supplied.
* Black wire:
To -ive terminal or to a substantial chassis
earth point ensuring a contact.
Check that all connections are secure.
Important;
Keep the wiring as short as possible to prevent voltage drop for this
may affect the operation of the unit.
Testing
After replacing the Waste-Safe®, fill the unit with 3.3 litres of clean
water. Do not fill above the fill line.
Make the connection to the battery and the RED Led tell-tale will
light showing that the unit is connected correctly and alive.
Run the engine and when the battery is fully charged, the water
heater will operate. In about 30 minutes the water will be up to
temperature and the heater will automatically cut out.
Refit the waste water tray.
Hot water may be drawn off when the waste water tray is dropped
down.
The waste water should be removed and emptied when water
appears in the drain holes.
Please note: In freezing weather, drain the unit over night and at
the weekends.
