2
Thank you for purchasing the TD-SC1 Load Cell Signal
Conditioner.
Please read this document in its entirety before using the
product to get the best performance and ensure safe and
proper operation.
In this manual, “this unit” or “TD-SC1” is used when referring to
both TD-SC1 (D/A) and TD-SC1 (485) models.
TD-SC1 (D/A) shows it has D/A, and TD-SC1 (485) shows it has
RS-485.
Features
o
Support for TEDS sensors makes calibration easy. Automatic
calibration is also possible when a TEDS sensor is connected.
o
An equivalent input function is included, making sensitivity
adjustment without actual loads easy.
o
Supports remote sense functions. Even using long cables
measurement is possible without losing precision.
o
Static strain measurement is possible. Identifying load cell
defects and other problems through plastic deformity is
easy.
o
Supports high and low limit comparison functions.
o
Supports hold functions, including peak hold, bottom hold
and holds with zone designations.
o
Attaches to common DIN rails.
o
Product complies with RoHS.
Included accessories
If anything is missing or damaged, contact us. (For contact
information, see the last page.)
Input/output connector plug
B2CF 3.50/18/180LR SN OR BX
1
Micro USB-B cable
1
Power input terminal bank cover (pre-installed on unit)
1
The following additional accessories are included with the
TD-SC1 (D/A).
KEC-NS0604-02 D/A terminal bank
1
D/A terminal bank cover
1
The following additional accessories are included with the
TD-SC1 (485).
KEC-NS0604-02 terminal bank for RS-485
1
RS-485 terminal bank cover
1
Disclaimers
Information is given about products in this manual only
for the purpose of example and does not indicate any
guarantees against infringements of third-party intellectual
property rights and other rights related to them. TEAC
Corporation will bear no responsibility for infringements on
third-party intellectual property rights or their occurrence
because of the use of these products.
Introduction
Company names and product names in this document are the
trademarks or registered trademarks of their respective owners.
