Teac plh4220sd, User Manual

Page: 25 / 27

Optional
PDP Wall-mounting Bracket Installation Guide
Read carefully before installation!
The installation guide should be retained for future reference.
Caution:
1. To avoid mistakes or hazards, do NOT attempt to install the TV by yourself. Refer all installation
to qualified servicing personnel.
2. Do NOT install the TV on a sloping wall that makes the TV screen slant over 25 degrees from the
vertical or it may tumble or cause injury.
3. The instructions in this guide must be followed to correctly install the TV.
4. It requires more than one person to install the TV.
5. Before installation, examine whether the wall conforms to the specifications and whether the
supplied parts can be fixed to it. The wall for mounting should sustain the weight of TV and
speakers, e.g. cement wall or brick wall. Do NOT attempt to install the TV on a flexible wall such
as sheetrock wall or plaster wall, unless the bolts are fixed on an area with standard building
rigidity which sustains the weight of the TV and speakers. If the rigidity of the wall can not be
measured, every mounting hole should sustain a frontal force of over 100N and a shearing force
of over 200N.
6. Use the specified electric drill and drill bit for drilling. The drilling holes should conform to the
specifications.
7. To avoid fire and shock, do NOT place a radiator, heater or humidifier below the installed TV.
8. The TV should be kept away from moisture, sensors and power line. The TV should be kept
away from impact and vibration.
9. Be sure that the power supply is disconnected before installation for fear of fire and shock.
Wall-mounting Installation Steps:
1. Take the brackets from the package, and check if there are serious defects (e.g. defective
junctures).
2. Adjust the bracket to the desired angle. Use the
(
bolt 5
)
to adjust the angle by joining the holes of
column beam 2 and holes of lever 8.
3. Drill locating holes of the specified dimension in a vertical wall of concrete or brick. The hole
size should be 11mm. The hole depth should accommodate the expanding tube of the bolt.
4. Fix the bolts into the drilled holes in step 3, and then cover each bolt with a metal washer. Join
the four mounting holes in the bracket to the four bolts in the wall, cover each bolt with a metal
washer, and then fasten with a screw nut. Check its rigidity by pulling the bracket.
5. Fix the fixture disk to the back cover of the TV using
(bolt 6) 4x
M8*40 bolts.
6. Wall-mount the TV by putting the four fixture disk into the four mounting holes A.
7. If the customer is not satisfied with the mounting angle, take down the TV and adjust the angle
before re-mounting.
8. After wall-mounting the TV, use bolts 5 to fix the fixture disk to avoid accidental slide.
Appendix