10
CAN recording available, CAN data received
Battery charge high*
Battery charge low*
Battery voltage low*
Using external power supply*
* These are shown when a BU-LX1000 battery unit is
connected.
NOTE
Battery charge indications are estimates.
Synchronization status indicators
These show the synchronization mode setting and
connection status.
Master mode, status OK
Master mode, status NG (not good)
Slave 1 mode, status OK
Slave 1 mode, status NG (not good)
Slave 2 mode, status OK
Slave 2 mode, status NG (not good)
Slave 3 mode, status OK
Slave 3 mode, status NG (not good)
k
Settings
This shows setting values.
Item
Explanation
SERIES
Sampling series
SAMPLE
Sampling frequency
AD
Quantization bit depth
REC CH
Number of recording channels
MONITOR
Monitoring channel
TRIGGER
Trigger setting
Select an item and press the ENTER button to enable
changing that setting value.
LXK Navi connection status
This is shown when LXK Navi is connected to an LX-1000.
This unit and LXK Navi cannot be used at the same time.
To use LXK Navi, turn the LX-1000 off once and disconnect
this device.
5. Basic operation
5-3. Trigger settings display
Stop trigger
Start trigger
The start and stop trigger settings are shown by icons.
No trigger
External trigger
Level trigger
Time
Timeout
If the mode is set to trigger and multiple triggers are set,
they are shown in the following order of priority.
Start triggers
Priority
Trigger
1
Level trigger
2
External trigger
3
Timeout
Stop triggers
Priority
Trigger
1
Level trigger
2
External trigger
3
Time
Summary of Contents for ER-LXRC1000
Page 1: ...Remote Control Unit Instructions for Use Z ER LXRC1000 D01349910F...
Page 37: ...37...
Page 38: ...38...
Page 39: ...39...