Teac CR-H700DAB, Owner'S Manual

Page: 61 / 320

ENGLISH
61
In case of trouble with the unit, please take the time
to look through this chart and see if you can solve the
problem yourself before you call your dealer or TEAC
service center.
Amplifier
No power.
e
Check the connection to the AC power supply.
No sound from speakers.
e
Check the connection to the speakers.
e
Adjust the volume.
e
Select proper source.
e
Pull out the headphones plug from PHONES jack.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar appliances.
Install the unit apart from them, or turn them off.
Remote Control Unit
Remote control unit does not work.
e
If the batteries are exhausted, change the batteries.
e
Use remote control unit within the range (5 m/16 ft.)
and point at the front panel.
e
Clear obstacles between the remote control unit and
the main unit.
e
If a fluorescent light is near the unit, turn it off.
Tuner
Cannot listen to any station, or signal is too weak.
e
Tune in the station properly.
e
If a TV set is near the unit, turn it off.
e
Install the antenna again after locating the best
reception position.
e
An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e
Press the FM MODE button.
Troubleshooting (1)
DAB tuner
No sound.
e
Ensure that the unit has been able to locate DAB
stations.
“NO stations Available” appears on the display.
e
Check that the DAB antenna is connected (see page
7).
e
Ensure that DAB broadcast covers your area.
Cannot access secondary services.
e
Not all services are accompanied by secondary
services. If a secondary service is available, the
secondary indicator (“>>”) is displayed next to the
station name.
Display goes out or “service off air” is displayed.
e
This may occur if a broadcaster changes the label
of a service or removes the label whilst you are
listening to it. The unit will try to retune to this
station. If the problem persists, follow the procedure
for channel scan on page 30.
A burbling sound is heard on some stations.
e
DAB system is able to produce quality audio from a
low level signal, but when the signal level is too low,
a “burbling” sound might be heard. To reduce this,
try repositioning your antenna to gain maximum
signal strength.
Network
Cannot connect to the Internet.
e
Check if your computer can connect to the Internet
using the same network.
e
Enter a correct pass key to the network.
e
Check the settings of your network’s firewall. The
unit needs access to the following UDP and TCP
ports as a minimum: 80, 554, 1755, 5000 and 7070.
Cannot listen to a station/Podcast.
e
The broadcaster has a temporary problem with
Internet connection.
e
Check if your Internet connection is not temporarily
disconnected or disturbed.