Teac CR-H500, Owner'S Manual

Page: 11 / 124

ENGLISH
11
A
AC Power Cord
Plug this cord into an AC wall socket.
<
Unplug the power cord when you are not going to
use the unit for long periods of time.
B
AUX 1 jacks
These jacks transmit an analog 2-channel audio
signal. Connect the components using commercially
available RCA pin cables.
Make sure to connect the cables as follows:
white plug
w
white jack
(L: left channel)
red plug
w
red jack
(R:right channel)
White (L)
Red (R)
White (L)
Red (R)
If you want to use a recorder (ex. a cassette deck or
a CD recorder, etc.) with the CR-H500, connect the
output jacks of the recorder to the AUX 1 IN jacks of
the CR-H500, connect the input jacks of the recorder
to the AUX 1 OUT jacks of the CR-H500.
<
Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
C
PHONO jacks
Connect the turntable’s RCA pin cable to the PHONO
jacks.
Make sure to connect the cables as follows:
white plug
w
white jack
(L: left channel)
red plug
w
red jack
(R:right channel)
<
Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
<
Moving Magnet (MM) cartridges can be used for this
unit.
D
SIGNAL GND
Connect the ground lead of the turntable to this
terminal.
<
This is not a safety earth.
<
If the turntable’s ground lead is not connected to this
terminal, hum noise may be heard.