![Teac AG-V8520 Owner'S Manual Download Page 12](http://html1.mh-extra.com/html/teac/ag-v8520/ag-v8520_owners-manual_4022696012.webp)
Audio Adjustments
Radio Reception
Auto Tuning
– 12 –
1. Press the TUNER button*.
* The TUNER button can also be pressed instead
when you want to listen to a station selected last
by changing from another source.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the
display).
●
This button is used to select Tuning or Preset scan
mode.
4. Press the UP or DOWN TUNING button (within 0.5 to
2 seconds). The next station broadcasting at a
frequency higher or lower than that of the current
station is automatically detected and tuned in.
●
By pressing and holding the TUNING button for
longer than 2 seconds, it will continue to control
(three times faster than normal speed).
POWER STANDBY/ ON Button
Press this button to turn the power on.
Press it again to turn the system off (power standby
mode).
The indicator lights up in power standby mode and
goes out when this unit is turned on.
SPEAKERS Select Buttons
These buttons are used to select speaker system A or B.
LINE STRAIGHT Button
When this button is pressed, the signal selected by the
source selector buttons is supplied directly to the
amplifier circuit, allowing you to listen to the source
with better sound quality. When the LINE STRAIGHT
mode is selected, the BASS, TREBLE controls will be
defeated.
BASS/TREBLE Tone Controls
These two tone controls – BASS and TREBLE – can be
used to obtain a "flat" frequency response or a tone
which suits your individual listening preference. The
Bass control adjusts low frequencies and the TREBLE
control adjusts the high frequencies.
BALANCE Control
This control is used to adjust the balance between the
left and right channels. Normally set to the center posi-
tion.
LOUDNESS Button
This button compensates for the non-linear response of
the human ear at low volumes. Set this switch to the
OFF position when listening at normal levels.
MUTING Button (on the Remote Control Unit)
Press this to mute (–20 dB) the sound from the speak-
ers and headphones when answering the telephone,
etc.
To restore the original volume, press the MUTING but-
ton again. While muting is engaged, the MASTER VOL-
UME level indicator will flicker.
POWER ON
LINE STRAIGHT
BASS/TREBLE
SPEAKERS
LOUDNESS
BALANCE
POWER ON
1
4
3 2
●
FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
Stereo
FM stereo broadcasts are received in stereo and
the STEREO indicator lights in the display.
Monophonic broadcasts are received in mono.
If FM broadcasts with weak signal strength are
received, the FM muting (–20 dB) function works
automatically to cut the signals, eliminating loud
noise.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
●
TUNED Indicator
''TUNED'' appears in the display when a broad-
cast is correctly tuned in.