50
TroubleShooting
If you experience problems with this unit, please take the time to
look through this chart and see if you can solve the problem
yourself before you call your dealer or TEAC service center.
No power
e
Check the connection to the AC power source. Check and
make sure the AC source is not a switched outlet and if it is,
the switch is turned on. Make sure there is power to the AC
outlet by plugging another item such as a lamp or fan.
No sound from speakers.
e
Adjust the volume.
e
Set the BALANCE control to the center.
e
Check the connection to the speakers.
The sound is noisy or humming.
e
The unit is too close to a TV set or similar appliances. Relocate
the units so they no longer interfere with each other, or turn
them off.
e
Connect the turntable’s ground cord to the SIGNAL GND
terminal.
Sound cuts off during listening to the music or no sound
even though power is ON.
e
Speaker impedance is less than prescribed for this unit.
e
Turn the power off and reduce the volume.
Low bass response.
e
Speaker polarity (
+
/
_
) is reversed. Check all speakers for
correct polarity.
Cannot listen to any station, or signal is too weak.
e
Make sure the antenna is properly connected.
e
Tune in the station properly.
e
If a TV is near the unit, turn it off.
e
Install the antenna again after relocating it to a better
reception position.
e
An external antenna may be required.
Though the broadcast is stereo, it sounds monaural.
e
Press the FM MODE button.
Remote control doesn’t work.
e
Press the POWER switch of the main unit to turn it on.
e
If the batteries are dead, change the batteries.
e
Use remote control unit within the range (5m) and point at the
front panel.
e
Clear obstacles between the remote control unit and the main
unit.
e
If a strong light is near the unit, turn it off.
If normal operation is not restored, unplug the power cord
from the outlet and plug it again.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or use
diluted neutral cleaning liquid. Be sure to remove any fluid
completely. Do not use thinner, benzine or alcohol as they may
damage the surface of the unit.
ENGLISH
Disposal of your old appliance
1. When this crossed-out wheeled bin symbol
is attached to a product it means the
product is covered by the European
Directive 2002/96/EC.
2. All electrical and electronic products should
be disposed of separately from the
municipal waste stream via designated collection facilities
appointed by the government or the local authorities.
3. The correct disposal of your old appliance will help prevent
potential negative consequences for the environment and
human health.
4. For more detailed information about disposal of your old
appliance, please contact your city office, waste disposal
service or the shop where you purchased the product.
