2. PRINTER SETUP
ENGLISH VERSION
2- 7
2.7 Loading the Media
NOTES:
1.
Please perform a media sensor calibration whenever you change the
media type.
2.
The size of the media which can be loaded inside the printer is as
follows:
Outer roll diameter: Max. 127mm (5”)
Inner core diameter: 25.4 (1”) mm or 38.1 mm (1.5”)
When the outer roll diameter exceeds 127 mm or the inner core
diameter exceeds 38.1 mm, an optional External Media Roll Hanger
is required. For details, refer to the Installation Guide for the
External Media Roll Hanger.
3.
Some media rolls are wound inside and the others are wound outside.
(See the diagram below.) Both types of media roll should be loaded
so that the print side faces up.
1.
Press down the Top Cover Release Button to unlock the Top Cover,
then fully open the Top Cover.
2.7 Loading the Media
This section describes how to load a media in the printer. This printer
accepts label rolls, tag rolls, and fanfold paper stocks. Please use
Tyco electronics approved media.
WARNING!
CAUTION!
Be careful not to touch the
Print Head Element when
opening the Top Cover.
Failure to do this may cause
missing dots by static
electricity or other print quality
problems.
Outside wound
Inside wound
Top Cover Release
Button
Top Cover
1.
Do not touch any moving
parts. To reduce the risk
of fingers, jewellery,
clothing, etc. being drawn
into the moving parts, be
sure to load the media
once the printer has
stopped moving
completely.
2.
To avoid injury, be careful
not to trap your fingers
while opening or closing
the Top
Cover.