Tyco Electronics Corporation
300 Constitutional Drive
Menlo Park, CA 94025 USA
No: RPIP-824-00
Rev: F
Date: April 28, 2006
Page: 6 of 11
© 2005-2006 Tyco Electronics Corporation. All rights reserved.
Unless otherwise specified dimensions are in millimeters [Inches dimensions are in between brackets]
If this document is printed it becomes uncontrolled. Check for the latest revision.
4.2.3 Inspection
1.
Positioning: Wires stripped 9.5 [0.375] should overlap each other at least 6.0 [0.250].
On wires stripped 12.5 [0.500] the overlap should be 9.5 [0.375].
2.
Heating: The solder ring shape should not be visible and a solder fillet, at least 4.5
[0.180] long, should be visible on one side of the leads. Fillet length should be 8.0
[0.315] for 12.5 [0.500] stripped wires. Lack of solder fillet may indicate overheating.
3.
Damage: The sleeve should not be split or cut and no wire strands should poke through
the sleeve. Fillet length should be 8.0 [0.315] for 12.5 [0.500] stripped wires.
Unacceptable:
Insufficient heat.
Contour of solder perform is visible.
Acceptable:
Solder has lost all appearance of ring shape.
There is a definite fillet visible along the wire interface.
4.3
Coaxial Cable Termination
4.3.1 Cable
preparation
1.
Remove 19.0 [.750] of the jacket.
2.
Remove 6.0 [.235] of the shield and dielectric to expose the conductor.
3. Cut shield 12.5 [.500] from cable jacket and fold back over the cable jacket.
